Seiko 7C17 Manuale Utente Scaricare il pdf (Pagina 6)

to select the axes speed high or low if the

machine is ROB (PROG) mode. The selected Jog speed is

0.0L, Z:00.0H).

In MDI mode, used to enter number.

Jog and MDI (manual data input) model selection. In WK mode, you

Partial Stop. This will stop the robot before executing the next step.

Enter [RUN] to start again. ESC key to escape the selection

backward.

The alternative key

display L or H at the end of Z axis coordinate.(Z:0

To reset an error. In MDI mode, used to enter number.

To extend/retract the iron tip. Pneumatic iron stroke is 10 mm.

can select second WK command group. Refer to the page 11.

Mode: Robot or Work

Coordinate

Data

Work Type

Travel Speed

Step Number

Program Number

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Nessun commento

Seiko 7C17 Manuale Utente Pagina 6