Seiko 7C17 Manuale Utente Scaricare il pdf (Pagina 30)

RS-P & N2 RS-P Iron Unit for Point Soldering

Solder Feed Up/Down &

Left/Right Adjust

Solder Feed Angle:

The solder feed approach angle should

be between 45 & 60 degrees from

horizontal. There are also 4 holes on

the tube holder. This will set the feed

angle per the application requirement.

Solder Feed Ad

ust:

To adjust the height of the solder

feed, use the upper micrometer to

raise or lower the height.

To adjust the solder feed left to

right, use the lower micrometer to

direct solder to the desired

location.

Feed Assembly Rotation:

On the opposite side of the iron

(blue oval) is a set screw.

Loosening this screw allows the

entire feed assembly to be rotated

into the correct position for

soldering.

Solder Feed Hei

ht:

Initial solder feed to be positioned just under

the iron tip. This will prevent the solder wire

from feeding directly into the iron tip plating

and wearing the tip prematurely. Once the

initial feed is set, you can then set the 2

feed

position. The goal is to feed into the joint area

and not to the tip itself.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Nessun commento

Seiko 7C17 Manuale Utente Pagina 30